Too compressed Rejection

I will master and send to ACX again

ACX wants all your chapters to match.

I did the record early morning when it was really quiet.

That leaves room echoes.

I can give you the basic ideas very fast.

1/2" PVC Plastic Pipe.
72" by 80" Heavy Furniture Moving Pads.
Four PVC Corners.

Screen Shot 2019-05-15 at 4.27.55.png

Cut the pipe into 8 lengths, each 20". Push the pipe and corners together into a square cave.

PVC-Studio2.jpg

Throw furniture moving pad over it to cover top and three sides. Put the microphone in the middle and talk into the open side.

– Next improvement is two pads and lay one pad on the table under the cave. You should do this one!

– Next improvement is three pads and throw two pads over the cave.

– Next improvement is four pads and hang one pad on the wall behind you.

And that’s as good as you can do with plastic pipes and furniture moving pads.

You are making one of these.

One poster tried blankets from his bed and it didn’t work right. They’re not heavy enough.

Koz

Kitchen Table Sound Studio
Revision 1

This is the parts list for the studio. Each of those eight plastic pipes is 20 inches long. No special parts or celebrities. They’re half-inch PVC. Four corners, four end-caps and two heavy 80" x 72" furniture moving blankets.


KitchenTableStudio-PartsList-Rev1.jpg
This is the frame construction. No glue.



KitchenTableStudio-Frame-Rev1.jpg
This is the finished studio. The pipes have end caps and the table has a cover, folded over.

KitchenTableStudio-Final-TwoOptions.jpg
It’s pretty amazing. You can stick your head in there and listen to the world vanish. That’s the end of room echoes.

It’s not soundproof. It’s sound resistant. I can still hear the house construction next door. Hard to ignore that jackhammer.

The pads are 72" by 80". They’re heavy. Each of mine weighs 17 lbs, but the more common 6 lb to 8 lb will work. Lighter is not good. We’re not after comfort or low shipping weight. We’re after dead weight. The sound has to move those pads to get in.

No glue. When you’re done using it and you need the kitchen table back, knock it apart and slide it under your bed.

Pipe notes: My Home Depot will sell me 24" PVC pipes pre-cut. You can use those and not have to cut anything, but you have to be careful to place the top pad so the 80" dimension is sideways. The top pad must meet the table on all three sides.

Koz

1 Like

dear Koz I got approved without build that scenario which was looks amazing!!!

Thank you,

Now I have a new challenge, I’m try to improve the quality, I would like to use a mac book pro

I got this quality which sounds no bad, just audacity tell me is out of RMS standard level
Other stuffs are ok, what I could do? You won’t believe how I achieved this quality :laughing: :unamused:

https://forum.audacityteam.org/t/i-think-is-a-good-quality-but-rms-is-out-of-standards/53016/1

Koz

thanks Koz with the new microphone and record with a third part software, then master with audacity I got approved straight away
and the quality is much better.

I still have some echo background but is much much better.

It made me pretty pleased to see the success. Which mic did you end up purchasing?