Page 2 of 2

Re: Auto Profile for Noise Reduction — Proposal

Posted: Thu Apr 10, 2014 11:17 pm
by Gale Andrews
kozikowski wrote:Whatever FFT requires to get enough to chew on.
Koz
Perhaps we want a warning as in Click Removal that the selection is too short?


Gale

Re: Auto Profile for Noise Reduction — Proposal

Posted: Fri Apr 11, 2014 12:21 am
by steve
Gale Andrews wrote:Perhaps we want a warning as in Click Removal that the selection is too short?
It's a slightly different case from the click removal issue. For click removal, the issue was that if the selection was too short it would do "nothing". In the case of Noise removal, even a single sample will do "something", just nothing useful.
Ideally the noise selection should be "several" seconds, but it's not easy to communicate that via the interface,

Re: Auto Profile for Noise Reduction — Proposal

Posted: Fri Jun 13, 2014 1:43 pm
by waxcylinder
Is somebody going to write a proposal based on this ???

Peter

Re: Auto Profile for Noise Reduction — Proposal

Posted: Sat Jun 14, 2014 3:56 am
by Gale Andrews
waxcylinder wrote:Is somebody going to write a proposal based on this ???
I doubt it. I've counted Koz's votes.

I suggest you archive this rather than delete it.


Gale