Page 1 of 1
adding effects progressively
Posted: Thu Dec 03, 2015 8:16 pm
by nieve
Hi! Is there a way to make effects fade into and out of an audio selection, instead of being applied abtruptly? I want normal audio to take off softly into altered audio, and then return in the same manner to its normal state. More specifically, I want oscillators and reverb to do that. Maybe Nyquist Prompt would help?
Re: adding effects progressively
Posted: Fri Dec 04, 2015 1:33 am
by kozikowski
I want oscillators and reverb to do that.
You were fine until right about there. You want what??
You can
simulate applying effects gradually by creating two tracks, one with effects and one without. Fade between them at whatever rate you want using a number of different tools.
Koz
Re: adding effects progressively
Posted: Fri Dec 04, 2015 2:44 am
by steve
You need to duplicate the track (Select the track then "Ctrl+D"), then apply the effect to one of the tracks, then "
crossfade" the two tracks.
Re: adding effects progressively
Posted: Fri Dec 04, 2015 5:40 am
by kozikowski
apply the effect to one of the tracks, then "crossfade" the two tracks.
Unless this isn't the effect you want... and I have an idea it's not.
Koz