Hello hello.
I was able to use Audacity to recover some 48k/16bit WAV files that had been corrupted during recording on a Zoom H6N. We were recording two channels.
I recovered it with the following settings...
Signed 16-Bit PCM
Little Endian
1 Channel (Mono)
Start Offset 0
Amount 100%
Sample Rate 48000
However, the recovered audio seems to be looping - it goes from roughly one second of one microphone to one second of the other microphone - and this is repeated throughout the entire 20+ minute interview, all on one track.
My question is - is there any way to automate a process that can split up this one file into its original channels? Something that would cut at an exact interval, paste to a new track, etc. etc - so that I can have the two different microphone seperated.
Thank you so much for your help. I'm on Mojave 10.14.3
Recovered Audio Looping In Intervals
Forum rules
This forum is for Audacity on macOS 10.4 and later.
Please state which version of macOS you are using,
and the exact three-section version number of Audacity from "Audacity menu > About Audacity".
Audacity 1.2.x and 1.3.x are obsolete and no longer supported. If you still have those versions, please upgrade at https://www.audacityteam.org/download/.
The old forums for those versions are now closed, but you can still read the archives of the 1.2.x and 1.3.x forums.
This forum is for Audacity on macOS 10.4 and later.Please state which version of macOS you are using,
and the exact three-section version number of Audacity from "Audacity menu > About Audacity".
Audacity 1.2.x and 1.3.x are obsolete and no longer supported. If you still have those versions, please upgrade at https://www.audacityteam.org/download/.
The old forums for those versions are now closed, but you can still read the archives of the 1.2.x and 1.3.x forums.