Help for Audacity on Windows.
Forum rules
This forum is for Audacity on Windows.
Please state which version of Windows you are using,
and the exact three-section version number of Audacity from "Help menu > About Audacity".
Audacity 1.2.x and 1.3.x are obsolete and no longer supported. If you still have those versions, please upgrade at
https://www.audacityteam.org/download/.
The old forums for those versions are now closed, but you can still read the archives of the
1.2.x and
1.3.x forums.
-
edwaptone
- Posts: 18
- Joined: Thu Sep 04, 2014 7:49 pm
- Operating System: Please select
Post
by edwaptone » Thu Sep 04, 2014 7:59 pm
ive riped some vinyl to audacity so that i can edit the tracks. but when i ply them back fro the recording they sound terrible. they sound muddy and like they have reverb on them? like theyve been recorded in a tunnel with a terrible mic etc.
im running my technics turntable into an amp and then running a phono to usb converter from the record out. its recording fine
please help cant figure it out

-
edwaptone
- Posts: 18
- Joined: Thu Sep 04, 2014 7:49 pm
- Operating System: Please select
Post
by edwaptone » Fri Sep 05, 2014 4:17 pm
have tried this, to no result have turned down input volume with some result but still alot of hiss behind and around the track. im using the alesis phono
to usb converter which acts as a sound card.....
-
Gale Andrews
- Quality Assurance
- Posts: 41761
- Joined: Fri Jul 27, 2007 12:02 am
- Operating System: Windows 10
Post
by Gale Andrews » Fri Sep 05, 2014 5:05 pm
Is it Alesis PhonoLink that you are using?
First you said it was muddy reverb and now you say it is hiss. So did you solve the reverb effect?
Have you turned the Audacity input slider up? If that slider is too low, you will get a low signal to noise ratio so you will hear hiss when you turn the playback volume up.
If you are still concerned please post an audio sample of the hiss. See
How to post an audio sample .
Gale
-
edwaptone
- Posts: 18
- Joined: Thu Sep 04, 2014 7:49 pm
- Operating System: Please select
Post
by edwaptone » Tue Sep 23, 2014 12:10 pm
hi thanks for your help- i have now sorted this out.
many thanks