# Noise tests on my audio recording setup

**URL:** <https://forum.audacityteam.org/t/noise-tests-on-my-audio-recording-setup/15901>\
**Category:** Recording Equipment\
**Created:** [September 14, 2010, 1:14pm UTC](https://forum.audacityteam.org/t/noise-tests-on-my-audio-recording-setup/15901 "2010-09-14T13:14:00Z")\
**Posts on this page:** 1\
**Showing post:** 1

<div class="post-metadata">

**Author:** ![waxcylinder](https://forum.audacityteam.org/user_avatar/forum.audacityteam.org/waxcylinder/32/37068_2.png) [@waxcylinder](https://forum.audacityteam.org/u/waxcylinder)\
**Post date:** [September 14, 2010, 1:14pm UTC](https://forum.audacityteam.org/t/noise-tests-on-my-audio-recording-setup/15901/1 "2010-09-14T13:14:00Z")

</div>

Following BillW58’s recent thread on noise removal tests (see [https://forum.audacityteam.org/t/noise-removal-tests/15869/1](https://forum.audacityteam.org/t/noise-removal-tests/15869/1) ) and some email correspondence I have had recently with another forum user (patcurci) on a related matter I have been led to do series of tests on my recording setup.

**Update:** following discussions on a recent thread by user brgavato (see: [http://forum.audacityteam.org/viewtopic.php?f=29&t=42674](http://forum.audacityteam.org/viewtopic.php?f=29&t=42674) ) I have added a further piece of kit into my recording chain. I am now also using a passive switch 3-in, 1-out to switch between my input devices. See below in the thread for review/tests.

**Equipment:**

1. Audacity 1.3.12 running on Dell Dimension 2400 desktop with Windows XP-HE
2. Edirol UA-1EX external USB soundcard
3. ARTcessories DJ-Pre11 phono preamp
4. Technics SL150 DD TT with SME 3009-11 (Improved) tone arm
5. Technics FM tuner St-X902l  
All the equipment is located in close proximity on or near my desktop – all of it is powered from a surge protected multi-way drop, itself powered from a single wall socket.  
All the test recordings were done with a null signal input and then amplified 25dB and played back on my attached active speakers at maximum volume. Numbers at the end of each test set-up are the available headroom for further amplification (after the original 25dB amp.). Note: the higher the number =\> the less noise on the track.

**Test Results**

1. Edirol soundcard attached to FM tuner (with tuner turned off) - loudish hiss generated 36.7
2. Edirol soundcard on its own, RCA leads isolated - hiss, but nowhere near as loud as with the FM tuner attached 49.7
3. Edirol soundcard on its own with RCA plugs touching - loud hum (disguises/hides the hiss) 18.1
4. Edirol soundcard connected to ART pre-amp, with preamp unplugged - very slightly lower hiss than in 2 50.0
5. Edirol soundcard connected to ART pre-amp, with preamp unplugged & transportable phone in nearby cradle/base-unit - same as 4 50.0
6. Edirol soundcard connected to ART pre-amp, with preamp on - loud noticeable hum, hiss not audible 20.9
7. Edirol soundcard connected to ART pre-amp, with preamp on, but careful placement of leads and unit - much reduced hum and hiss noticeable again 36.4
8. As 7 but with TT RCA leads unplugged and earth wire removed - loud hum and hiss, worse on R channel 20.2
9. As 7 but with TT earth only connected to ART - sounds same as 8 but waveform looks “cleaner” 21.2
10. As 7 with TT RCA leads connected but no earth - nasty loud rasping hum, masks hiss 7.1
11. all re-connected properly and careful lead placement - sounds same as 7

**Conclusions:**  
1 & 2 above =\> that my FM tuner contributes a little noise even when turned off, on standby  
2 & 4 =\> that my Edirol generates a little hiss  
4 & 5 =\> the transportable phone and base unit in close proximity appear to generate no additional noise  
7 =\> that the ART (or the TT/arm/wiring/cartridge) adds some hum to the hiss provided by the Edirol  
6,8, 9 & 10 =\> my right channel is noisier than the left  
6 =\> that careful placement of the RCA and earthing leads is important in reducing noise  
10 & 9 (&7) =\> proper TT earthing is absolute critical (but I hope we all knew that already)

_And do remember to turn down the speaker volume when the tests are finished - otherwise you may blow the speakers!_

I need to point out that the “noise” in all these tests is totally undetectable with normal recordings (and my aging ears) even when listened to on high quality playback equipment and that therefore I make no attempt to remove the “noise” from my recordings as I do not wish to mess with or remove any of the real signal any more than necessary.

WC

---

_[View the full topic](https://forum.audacityteam.org/t/noise-tests-on-my-audio-recording-setup/15901)._
