Am I correct in assuming I can only adjust the volume by track not by clip?

In other words, when I adjust a volume it applies to the entire track and within in any and all clips will be adjusted.
And if I want any clip to be lower or higher than the other on that track, I must move the clip in question to a track of its own?
Kindly, KA :smiley:

No you can select any individual clip and then apply any effect, including Amplify, to just that selected clip.

To select any individual clip, just double-click in it.

In fact you can make selections for acting on using click and drag in the waveform.

Peter.

Thank you for your help! Actually it stumped me for a little bit, until I discovered I can amplify in the negative :laughing: . Success!