Hi everybody,
I’m a newbie here…
I’m browsing much and know this forum.
I’m doing my last project now about Honeypot.
I use dionaea as my honeypot tools.
When I installed the dionaea, I meet the prob is…
make: *** no targets specified and no makefile found. stop
This is happen while i type “make” after I configure the dionaea as the command below:
./configure --with-lcfg-include=/opt/dionaea/include/
–with-lcfg-lib=/opt/dionaea/lib/
–with-python=/opt/dionaea/bin/python3.1
–with-cython-dir=/usr/bin
–with-udns-include=/opt/dionaea/include/
–with-udns-lib=/opt/dionaea/lib/
–with-emu-include=/opt/dionaea/include/
–with-emu-lib=/opt/dionaea/lib/
–with-gc-include=/usr/include/gc
–with-ev-include=/opt/dionaea/include
–with-ev-lib=/opt/dionaea/lib
–with-nl-include=/opt/dionaea/include
–with-nl-lib=/opt/dionaea/lib/
–with-curl-config=/opt/dionaea/bin/
–with-pcap-include=/opt/dionaea/include
–with-pcap-lib=/opt/dionaea/lib/
–with-glib=/opt/dionaea
Anybody know what is mean?
Why it’s make *** no targets specified and no makefile found. stop ?
Regards,
Nani