Hi All,
I have used audacity successfully on a few occasions recently to record from my vinyl decks and mixer. however for some reason audacity will no longer detect any signal when I monitor or record.
I use a Citronic AC1 USB to connect from my mixer to my laptop (Windows 10).
I use the following set up:
Audio Host: MME
Recording Device: USB codec 2
Recording Channels: 2 stereo
Playback Device: Speakers (Realtek)
As I said I have used these settings a few times recently without issue.
Since discovering this problem I have uninstalled and re installed my USB drivers and uninstalled and reinstalled Audacity software but no change.
I have checked the decks by playing them through an amp and speakers and they work fine.
I’m not sure how I could troubleshoot the Citronic USB device or troubleshoot further my laptop.
Any suggestions would be greatly appreciated, thanks!